![]() ![]() Shift edges to get rid of any thin lines from the old background.Blur edges to make the image fit better in its new setting.Here you can also hide all the evidence of photo manipulation: You can create an actual-size clone or a miniature copy, depending on your artistic decision. Adjust the size of the cutout ( Photo 1 ) and move it around to find the best place for it. Replace the BackgroundĪdd Photo 2 as the new background. If some imperfections remain, you can fix them in Step 3. Add or subtract areas with the help of the Mask Brush – just use it to paint over the object’s borders. Now you can select the object more precisely. This tool works best when selecting objects with colors that contrast with the background colors. Use the Lasso to select the object by tracing its outline. If this is not the effect you’re going for, find the right balance by adjusting the slider. Adjust the Boundary Smoothness: overly sharp edges will make you look like a cardboard cutout and, because of the blurred boundaries, you will look like a ghost. Mark the foreground object you want to keep with the green Brush + tool and add a few strokes to the background with the red Brush- tool. ![]() Next, you need to select the foreground there are two ways to do this: Upload Photo 1 to the editor and open the Change Background tab. All you need is a couple of similar photos – let’s call them Photo 1 and Photo 2. You don’t have to wait for a scientific breakthrough to have yourself cloned. Little by little, paint over all the remaining area until you have a pretty realistic image of a levitating person. Then release the Alt key and mask the artifact with the copied background. Press and hold Alt, then click on the background to copy the area. You can get rid of them with the help of the Stamp tool. Pay attention, as there may still be so-called artifacts left – tiny parts of the object that could not be removed. Don’t forget to select the object’s shadow!Ĭlick Start Erasing and let the editor work its magic. This will help you select the object more precisely and not leave a single detail behind. Press and hold the space bar, then use the Hand tool to move around the image. Zoom in on the picture by holding Ctrl and scrolling up. Or you can click Reset Selection to start over. To deselect parts of the image, use the Selection Eraser tool. This depends on the object’s size and the background, so try different variation values until you find the one that works best for your image. That’s why it is important to adjust the Variation slider, as it affects the range from which these pixels can be taken. When you erase an object, the program replaces it with pixels from the image.
0 Comments
Leave a Reply. |